DIY - Ariana and Alexa’s friendship bracelets. I know I’m not the best at explaining things but I hope this helps :)
1 - Measure the string around your wrist, you’ll want it to be a little bigger than your wrist so that you have enough room to tie it in knots so it won’t come loose! Once measured, cut the string to that length.
2 - There are two ways for you to tie the knot at the end of the string; either tying it as a knot on it’s own or getting one of the small beads and threading that through the hole and tying the bead on (Personally I prefer this as I find it keeps the bracelet on longer).
3 - Once you’ve tied the knot and you know it’s secure and that the beads don’t go through and fall off, you’re going to want to put the beads on in a cute pattern you like! (If you want you can lay them out in an order before you put them on)
4 - When you get to around the middle, stop and begin spelling out your name, your friends name or a cute word! Then put that on and finish putting the rest of the beads on. (although if you’re not putting words on it don’t do this step)
5 - Finally, leaving about a finger width (or less) gap, you’re going to tie the bracelet together so that it’s secure in a circle and put it on :)
Have fun :) xxxx - anouska